![]() Subsequently, you’ll have a flat bottom with dimensions of 8ft x 7.75ft for your halfpipe. Press the two long sides of the wooden frames against each other and use screws to attach them.Finish installing all the 22 45-inch lumber pieces you prepared.Line the lumber up to both sides of the wooden frame and drill its ends. And like the framing we installed, the narrow side of the 2×4 lumber should be flush against the box for the flat bottom. Grab three screws and drill along the first 8-inch-interval mark on the frame.Each box for the flat bottom will use 11 of them. Next, prepare 22 pieces of 2×4 lumber cut to 45” long.Put tick marks at 8-inch intervals on the longer sides of the boxes.Keep the narrow sides facing up to level with the lowest part of the transition. Using 2×4 lumber, frame up two wooden boxes that are 4ft x 7.75ft each. The flat bottom connects the two transitions.Repeat this step with the other transition. Otherwise, the curve may not be as smooth as we originally planned. Make sure you drill with the board’s narrow side against the transition.Begin from the lowest part of the ramp until you finish at the top or deck of the halfpipe. Finally, drill the 12 remaining lumber studs on the transition part of the halfpipe.Next, drill another stud on the other bottom corner of the ramp or at the right angle facing the curve.Keep the lumber and curve leveled to ensure the ramp is connected at the right points. Drill one stud on the lowest part of the transition, using three 1.5” screws at each end for firmness.Position them mirroring each other and with a distance the same as the lumber’s length. Cut 1/8” off the lumber to square the entire ramp. Double this number to support all four halfpipe walls. Prepare 12 2×4 lumber pieces (8 ft in length) plus two more for the base. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |